Hello,
I'm utilizing a map of scaling factors that I have imported into HYDRUS 3D and I had a question about how they are implemented. I saw in the technical manual, and some literature, that the scaling factors are taking reference hydraulic functions (defined by the retention and conductivity parameters for each material) and multiplying them by the scaling factors at each node, but where they are implemented into the calculation procedure is a little vague. Are the scaling factors applied before or after the calculations for each time step? In other words, are they modifying the hydraulic properties at each point before the result for each time step is calculated, or taking the calculated result for each point and multiplying them by their respective scaling factors? The former makes more sense, but I just want to make sure.
Implementation of scaling factors

 Posts: 12
 Joined: Tue May 05, 2015 5:17 pm
 Location: USA
Re: Implementation of scaling factors
The former. Scaling factors modify the soil hydraulic properties, which are used to solve the Richards equation, i.e., they are used before the discretized matrix equation is assembled. J

 Posts: 12
 Joined: Tue May 05, 2015 5:17 pm
 Location: USA
Re: Implementation of scaling factors
Great. Thanks for the quick reply! Is there a way to see what the modified hydraulic properties are for each observation node before the calculations? There are outputs of water retention (theta and h) for the observation nodes in OBSNOD.OUT, but those are from after the calculations correct? If so, I have noticed in this example run I did where I used only scaling factors for the pressure potential that the pressure potential values in the HYDRUS GUI output and the OBSNOD.OUT file do not match up (see attached at t=1000). I thought maybe that was due to the scaling factor for that particular node, but it still does not make sense since the scaling factor for that particular node is 1.10. It may seem overboard, but I want to understand what exactly the scaling factors are doing within the model
 Attachments

 OBSNOD comparison.png (209.46 KiB) Viewed 79 times
Re: Implementation of scaling factors
When HYDRUS GUI makes the graph for observation nodes, it reads values directly from the ObsNode.out file. The value in the graph and in the output files cannot be different, that's impossible. J.