I am using HYDRUS 1D for a capilary process, working in the pressure range, and I have observed that the model stops when the initial conditions of the soil profile is lower than -1.0 e10 cm.
The bottom and top boundary conditions are -0.001 cm and atmospheric conditions. The minimum time step is 1.0 e-12 cm and the number of cell is 1000, in a 5-cm high soil column. I have run the model for different soils (from loamysand to clay) and the results are allways similar.
Is it my fault or HYDRUS can not run with initial conditions lower than -1.0 e10 cm?
A discussion forum for Hydrus-1D users.
2 posts • Page 1 of 1