Matlab run problem

A discussion forum for Hydrus-1D users.
Post Reply
aliko
Posts: 14
Joined: Sun Jul 03, 2016 3:01 pm
Location: Brazil

Matlab run problem

Post by aliko » Fri Oct 05, 2018 7:32 am

Hi
I just rewrite the example of hydrus run by matlab (https://www.pc-progress.com/Downloads/T ... Hydrus.pdf),
but there is something wrong that the run is not done and Matlab stays busy for ever.
Please find the attached file and see if you can find where I made mistake.
Thanks
Attachments
mfiles.zip
(1.66 KiB) Downloaded 60 times
Top
Jirka
Posts: 4712
Joined: Sat Mar 16, 2002 3:47 pm
Location: USA
Location: Riverside, CA

Re: Matlab run problem

Post by Jirka » Fri Oct 05, 2018 8:52 pm

Someone else will have to help with this question. I'm not an expert on MatLab. J.
Top
aliko
Posts: 14
Joined: Sun Jul 03, 2016 3:01 pm
Location: Brazil

Re: Matlab run problem

Post by aliko » Sun Oct 07, 2018 5:02 pm

Thanks for reply, could you please post the contact of relevant person about matlab and hydrus in PC progress.
Ali
Top
Nivea Miranda
Posts: 1
Joined: Sun Dec 23, 2018 1:31 am
Location: Brazil

Re: Matlab run problem

Post by Nivea Miranda » Sat Jan 05, 2019 10:58 pm

Hi Aliko,

I'm facing the same problem here and couldn't find a solution yet.
Did you managed to solve it?

Thank you,
Nivea Miranda.
Top
Gal
Posts: 3
Joined: Sun Nov 19, 2017 1:42 pm
Location: Israel

Re: Matlab run problem

Post by Gal » Sun Jan 06, 2019 5:23 pm

Hi Aliko

Try un-checking the "Hit Enter at End?" check-box in the "Print information" menu within your HYDRUS project.

Gal
Top
rajsekhar
Posts: 10
Joined: Thu Nov 29, 2018 5:58 am
Location: India

Re: Matlab run problem

Post by rajsekhar » Thu Jan 24, 2019 1:29 pm

I too faced this problem but after unchecking the hit enter at end, it's working fine.
Top
Post Reply

Return to “Hydrus 1D”