Hi, I am using the RETC code (version 6.02) for fitting the retention and hydraulic conductivity data obtained with the evaporation method. I used the dual porosity model (Durner, 1994). However I can't find the hydraulic conductivity model used by the program. It is the same than the Priesack and Durner (2006)? The manual does not specify this information. Thank you very much.
Rafael
Hydraulic conductivity using dual porosity model
-
rafaelvillarreal
- Posts: 5
- Joined: Tue Feb 23, 2021 1:11 am
- Location: Argentina
Re: Hydraulic conductivity using dual porosity model
Yes, it is.
We have never updated the old RETC manual, which thus describes only the VG and BC models. You can find the description of all models (including Kosugi and Durner) implemented in RETC in the Hydrus manual.
J.
We have never updated the old RETC manual, which thus describes only the VG and BC models. You can find the description of all models (including Kosugi and Durner) implemented in RETC in the Hydrus manual.
J.
-
rafaelvillarreal
- Posts: 5
- Joined: Tue Feb 23, 2021 1:11 am
- Location: Argentina
Re: Hydraulic conductivity using dual porosity model
Thank you very much for the answer, Professor! Best regards.
Rafael
Rafael
Re: Hydraulic conductivity using dual porosity model
I believe that this was all described in the RETC help, but Microsoft stopped supporting the hlp format in Windows 10, and thus I cannot open it any longer. J.