SETUP problem

amanda linqing · Post by **amanda linqing** » Mon Aug 11, 2008 2:03 am

Dear all,
There is something wrong in my setup of STANMOD 2.5. In the process of setup some errors always emerge like below:

Feature: program files
component: bin_program_org
file: c:\program files\urc\stanmod\original stanmod programs \CFITM\CFITdd48. rra
error: ?Î?ý?»?ý?·?¨the parameters are incorrect ?©

Post by **Mirek** » Mon Aug 11, 2008 8:34 am

Hello Amanda,

I have downloaded and installed the latest version of STANMOD (StAnMod_25.exe) without any problems. However, after the installation I noticed that file C:\Program Files\UCR\STANMOD\Original STANMOD Programs\CFITM.IN has a strange date. The date is “25.4.1617” which obviously is an error. I remember that a long time ago there was an error in the STANMOD project manager and this error was causing incorrect dates like this one. Although the date was incorrect, the rest of the file was correct and it was possible to work with it. I think that this wrong date can cause problems on some computers, especially if you have an antivirus that checks file dates. Were you able to finish STANMOD installation after this error message or the installation failed?

Mirek

amanda linqing · Post by **amanda linqing** » Wed Sep 03, 2008 9:05 am

Dear Mirek
Thank you for your reply. I cannot finish STANMOD installation after this error message and some of my friends also have this problem. I close my antivirus files before setup but the same question still exist.

Post by **Mirek** » Wed Sep 03, 2008 9:21 am

OK, we will prepare a new installation program. It could be available for downloading in a couple of days.

Regards
Mirek

Post by **Mirek** » Sun Sep 07, 2008 8:20 am

Today we released the new installation program (StAnMod_26.exe), it is available at http://www.pc-progress.cz/Pg_Hydrus_Dow ... rm_SAM.htm. Please, let me know if the new installation fixed your problem or not.
Thanks,
Mirek

amanda linqing · Post by **amanda linqing** » Mon Sep 08, 2008 9:14 am

Dear Mirek,
Thank you very much! I set up the program successfully.
Thanks again.