Hydrus 1D-Profile information

A discussion forum for Hydrus-1D users.
Post Reply
ES_92
Posts: 16
Joined: Sun Dec 06, 2020 11:22 am
Location: Germany

Hydrus 1D-Profile information

Post by ES_92 » Sun Dec 06, 2020 11:30 am

Hello,
I am a beginner in learning Hydrus 1D. I was doing the exercise 1 and simulated the result. But in the profile information I do not see the pressure head with time. Can anyone help me how can I see the pressure head variation with time? I have attached the picture. Thanks in advance.
Attachments
hydrus.PNG
hydrus.PNG (43.1 KiB) Viewed 725 times

Jirka
Posts: 5216
Joined: Sat Mar 16, 2002 3:47 pm
Location: USA
Location: Riverside, CA

Re: Hydrus 1D-Profile information

Post by Jirka » Mon Dec 07, 2020 7:02 pm

I can see in your graph both the initial pressure head profile (with h=-100, except for the top nod), and then (likely) the steady-state, fully saturated profile (with h=1 cm). I guess you will need to specify print times at shorter times to see what happens between these two states. J.

Post Reply