convergence error groundwater recharge

A discussion forum for old Hydrus-1D users.
Post Reply
Posts: 1
Joined: Wed Sep 16, 2020 8:59 am
Location: Australia

convergence error groundwater recharge

Post by bobtom059 » Wed Sep 16, 2020 10:26 am

I have been attempting to model groundwater recharge, using Hydrus 1D, but I encounter a convergence error at day 284 out of 933 day period, with root water uptake and root growth selected. I have run the model only considering water flow and it has come out successful. I am using the Hargraves Formula, with boundary conditions selected; upper boundary condition = atmosphere BC with surface run off and lower boundary condition = free drainage. My root water uptake model uses the Feddes water uptake reduction model and have selected my crop data to be constant (crop being sugarcane). I have my 400cm soil profile containing three different soil materials. I have attached a picture of my soil profile where red = clay loam, blue = sandy clay loam and green = sandy loam

I have tried the following to solve the error:
- Increase minimum time steps
- Increase water content toleration
- Select “with air-entry value of -2cm”
- Increased node density close to the surface
- Increased maximum number of iterations
- varied the lower limit of the tension interval
- have looked through tutorials and the discussion page for solutions
Although some of these have helped to extend the time to 284 days, I am still yet to run a successful model. I suspect the abrupt changes of the soil materials may be affecting the model as through your tutorials with a uniform soil body, the model seems to run fine. Any suggestions would be much appreciated.
(597.44 KiB) Downloaded 903 times
soil profile.png
soil profile
soil profile.png (1.79 KiB) Viewed 58799 times

Post Reply