Errors in solute when surface layer BC is applied

A discussion forum for Hydrus-1D users.
Post Reply
theodorb
Posts: 12
Joined: Sun Jul 01, 2018 3:54 pm
Location: Israel

Errors in solute when surface layer BC is applied

Post by theodorb » Tue Nov 19, 2019 1:37 am

Hi,
I am running a 1D irrigation model with Atmospheric BC allowing a surface layer and standard solute transport. My results are way off when allowing even 1 mm of surface water h. Results are OK, as far as I can say, when h=0.0.

Any idea why this could happen?

Thanks,

Theodor Bughici

Jirka
Posts: 4827
Joined: Sat Mar 16, 2002 3:47 pm
Location: USA
Location: Riverside, CA

Re: Errors in solute when surface layer BC is applied

Post by Jirka » Tue Nov 19, 2019 1:49 am

Not without seeing the project. J.

theodorb
Posts: 12
Joined: Sun Jul 01, 2018 3:54 pm
Location: Israel

Re: Errors in solute when surface layer BC is applied

Post by theodorb » Tue Nov 19, 2019 5:55 pm

Hi, I have attached the input files.

Thanks,

Theodor Bughici
Attachments
Bermudagrass_1D_irrigation.zip
(50.49 KiB) Downloaded 11 times

Jirka
Posts: 4827
Joined: Sat Mar 16, 2002 3:47 pm
Location: USA
Location: Riverside, CA

Re: Errors in solute when surface layer BC is applied

Post by Jirka » Tue Nov 19, 2019 6:25 pm

I do not see any problem. Jl
Attachments
Work.rar
(1.29 MiB) Downloaded 10 times

theodorb
Posts: 12
Joined: Sun Jul 01, 2018 3:54 pm
Location: Israel

Re: Errors in solute when surface layer BC is applied

Post by theodorb » Tue Nov 19, 2019 9:55 pm

Strange. The files you've attached run OK for me as well but the ones I've sent didn't.
I'll look into it. Thanks a lot anyway.

Theodor Bughici

Jirka
Posts: 4827
Joined: Sat Mar 16, 2002 3:47 pm
Location: USA
Location: Riverside, CA

Re: Errors in solute when surface layer BC is applied

Post by Jirka » Tue Nov 19, 2019 11:37 pm

I may have done some minor modifications, which I do not recall. Simply compare the two projects to find out. J.

Post Reply