inverse not well

A discussion forum for Hydrus-1D users.
Post Reply
T ze
Posts: 5
Joined: Wed Feb 27, 2019 11:28 am
Location: China

inverse not well

Post by T ze » Sun Mar 24, 2019 4:21 am

Hello,
I want to inverse the hydraulic parameter α and the dispersion coefficient for the solute tritium with the measured tritium profiles, I partition the soil into five layers, as it is not reasonable to inverse for five layers, so i want to make all the layer have a same α and disp. with the optimal inverse result. I I have changed the set in fit. in files from "1" to "2", but it donot behave well. So, can you help me to check it, and give me some suggestion how to modify the setting files in the hydrus? The detial hydrus files is below.
Thanks, hope for your reply!
Attachments
Hydrus files.zip
(1.38 MiB) Downloaded 30 times

Jirka
Posts: 4799
Joined: Sat Mar 16, 2002 3:47 pm
Location: USA
Location: Riverside, CA

Re: inverse not well

Post by Jirka » Sun Mar 24, 2019 7:28 am

If someone wants to look at it, go ahead. I’m traveling in Europe and will not have time for that. J.

Post Reply