Page 1 of 1

Matlab run problem

Posted: Fri Oct 05, 2018 7:32 am
by aliko
Hi
I just rewrite the example of hydrus run by matlab (https://www.pc-progress.com/Downloads/T ... Hydrus.pdf),
but there is something wrong that the run is not done and Matlab stays busy for ever.
Please find the attached file and see if you can find where I made mistake.
Thanks

Re: Matlab run problem

Posted: Fri Oct 05, 2018 8:52 pm
by Jirka
Someone else will have to help with this question. I'm not an expert on MatLab. J.

Re: Matlab run problem

Posted: Sun Oct 07, 2018 5:02 pm
by aliko
Thanks for reply, could you please post the contact of relevant person about matlab and hydrus in PC progress.
Ali

Re: Matlab run problem

Posted: Sat Jan 05, 2019 10:58 pm
by Nivea Miranda
Hi Aliko,

I'm facing the same problem here and couldn't find a solution yet.
Did you managed to solve it?

Thank you,
Nivea Miranda.

Re: Matlab run problem

Posted: Sun Jan 06, 2019 5:23 pm
by Gal
Hi Aliko

Try un-checking the "Hit Enter at End?" check-box in the "Print information" menu within your HYDRUS project.

Gal

Re: Matlab run problem

Posted: Thu Jan 24, 2019 1:29 pm
by rajsekhar
I too faced this problem but after unchecking the hit enter at end, it's working fine.