Problem opening the output file profile information

A discussion forum for Hydrus-1D users.
Post Reply
July
Posts: 6
Joined: Wed Sep 02, 2015 9:59 am
Location: Germany

Problem opening the output file profile information

Post by July » Sun Oct 04, 2015 12:42 pm

Hello all,

I have got a problem opening the output file profile information. Is this a bug in Hydrus or are some presetted parameters or other settings the cause of it? In Hydrus example projects I can open the profile information. Another problem is that I simulate far too high cumulative bottom fluxes of over 1,000 cm. The reality should be about 10 cm. What could be the cause of that?

Thanks, July

Jirka
Posts: 4980
Joined: Sat Mar 16, 2002 3:47 pm
Location: USA
Location: Riverside, CA

Re: Problem opening the output file profile information

Post by Jirka » Mon Oct 05, 2015 1:35 am

It is highly unlikely that there would be such a trivial bug (such as opening output files) in HYDRUS, considering that it has thousands of users. More likely is that you have some problems with your input or use inadequate discretization and other parameters, so that some output values printed into this output file are out of the range of considered format. You should check this output file (Nod_inf.out in the project folder) and try to open it using notepad, or other text software. See the rules about discretization described in HYDRUS FAQs. J

Post Reply