Integrating profile water content over depth

A discussion forum for Hydrus-1D users.
bek
Posts: 1
Joined: Mon Aug 12, 2019 6:18 am
Location: Canada

Re: Integrating profile water content over depth

Post by bek » Fri Aug 16, 2019 5:54 pm

Jirka wrote:
Mon May 08, 2017 6:42 pm
Note that the program also calculates and prints into T_level.out the water storage in the entire profile.
Although the GUI support only 10 observation nodes, the computational module supports 100 observation nodes. You can thus modify the Profile.dat (and HYDRUS1D.DAT) input file manually, you will get information for up to 100 observation nodes.

J.
Hello Dr. Jirka,
I am trying to run a thermal simulation. I have up to 20 observation nodes and followed the discussion to make the proper adjustment for the Observation nodes and was able to fit all the data. But the model is giving me the following error message.
Attachments
error.JPG
error.JPG (56.67 KiB) Viewed 1258 times

Jirka
Posts: 5268
Joined: Sat Mar 16, 2002 3:47 pm
Location: USA
Location: Riverside, CA

Re: Integrating profile water content over depth

Post by Jirka » Fri Aug 16, 2019 8:26 pm

The quotation that you give is related to the direct module (i.e., h1d_calc.exe), which indeed allows you to have up to 100 observation nodes. It is not related to the inverse module (i.e., h1d_clci.exe), which allows you to have up to 10 observation nodes. And you are using the inverse module. J.

Post Reply