"Enter to continue" did not appear after hydrus successfully ran
Posted: Mon Nov 07, 2022 8:37 am
Hello,
Please I need clarification on my project. I am simulating water flow through a vertical soil column (comprising a sandy loam layer and gravel as the bottom layer). I set observation nodes at different depths and have field moisture content values at each of these depths. I used an inverse solution stating the maximum iteration as 10 and setting the upper boundary condition as constant pressure and the lower boundary condition as free drainage. I set the initial condition using a linear depth distribution with a pressure head of 100 at the top and 0 at the bottom.
After the project successfully ran, the 'press enter to continue" did not appear.
Thank you.
Please I need clarification on my project. I am simulating water flow through a vertical soil column (comprising a sandy loam layer and gravel as the bottom layer). I set observation nodes at different depths and have field moisture content values at each of these depths. I used an inverse solution stating the maximum iteration as 10 and setting the upper boundary condition as constant pressure and the lower boundary condition as free drainage. I set the initial condition using a linear depth distribution with a pressure head of 100 at the top and 0 at the bottom.
After the project successfully ran, the 'press enter to continue" did not appear.
Thank you.