BC. options in Hydrus 2D/3D version 1.10

A discussion forum for users of the new HYDRUS 2D/3D. HYDRUS is a software package for simulating water, heat and solute movement in two- and three-dimensional variably saturated media. Happy Posting!
Post Reply
nessrine
Posts: 18
Joined: Sun Jun 28, 2015 9:38 pm
Location: Tunisia

BC. options in Hydrus 2D/3D version 1.10

Post by nessrine » Wed Nov 20, 2019 1:53 pm

Dear Jirka

I'm working with Hydrus 2D/3D version 1.10 I'm solving water flow problem under surface irrigation (like flood irrigation )
the irrigation is applied two time per week , so during irrigation I have atmosperic BC and variable flux BC at the same time

my question :
Should I work with variables flux BC and I select the option when HYDRUS treats the time-variable flux boundary conditions similarly as atmospheric fluxes ?


thank you in advance

Jirka
Posts: 4983
Joined: Sat Mar 16, 2002 3:47 pm
Location: USA
Location: Riverside, CA

Re: BC. options in Hydrus 2D/3D version 1.10

Post by Jirka » Wed Nov 20, 2019 6:29 pm

I would think so. Although I have to admit that I do not have version 1 installed on my PC any longer since it is more than 10 years since we replaced it with version 2, and later with version 3. J.

nessrine
Posts: 18
Joined: Sun Jun 28, 2015 9:38 pm
Location: Tunisia

Re: BC. options in Hydrus 2D/3D version 1.10

Post by nessrine » Fri Nov 22, 2019 2:31 pm

ok thank you for your response

Post Reply