I am David Moret from Spain
I want to simulate, using HYDRUS 2D, the water infiltration and the soil surface runoff under a drip irrigation process on a sloped soil surface (see attached figure), using in the dripping point a constat water flux.
However, the simulator stops when a constant water flux is applied in the dripping point, and HYDRUS only runs when a constant h < 0 is applied in the wetting point. In this case, no water surface runoff can be simulated.
Is there any option to simulate with HYDRUS 2D a drip irrigation process with a constant water flux, and estimate the surface water runoff, when existing?
A discussion forum for users of the new HYDRUS 2D/3D. HYDRUS is a software package for simulating water, heat and solute movement in two- and three-dimensional variably saturated media. Happy Posting!
1 post • Page 1 of 1