Page 1 of 1

Inverse Solution Fit Plots - Some not showing up

Posted: Wed Jan 09, 2019 12:38 am
by swhitman
Hello,

I am simulating flow in some columns and am comparing the results to measured values for suction, inflow, outflow, and water content.

Currently I am trying to view the fit plots for inflow and outflow, but am only getting the observed data to show for the variable flux/head boundary 1. The data will not plot for variable flux/head boundary 2, but the values are in the FIT.OUT file, where I can plot them externally.

Is there something I need to do for those data to show up in the default plots in the GUI? I show my coding and resulting plots below.

Thank You,
VFlux1.PNG
VFlux1.PNG (17.11 KiB) Viewed 251 times
VFlux2.PNG
VFlux2.PNG (16.25 KiB) Viewed 251 times
InverseDataCoding.PNG
InverseDataCoding.PNG (21.21 KiB) Viewed 252 times

Re: Inverse Solution Fit Plots - Some not showing up

Posted: Sat Jan 12, 2019 7:57 pm
by Jirka
Indeed, the GUI currently displays inverse data only for boundary fluxes with Kode<=6, while time-variable head/flux BCs (2, 3, and 4) have Kode=7, 8, and 9 (respectively). We need to fix this bug in the GUI. These fluxes are indeed only printed into the Fit.out file and considered in calculations. Thanks for letting us know about this bug. We will fix it asap. J.