Page 1 of 1

No velocity or velocity vector results

Posted: Tue Aug 28, 2018 4:08 pm
by Lando
Hello,

I am running a simple 2D profile model to simulate upward preferential flow from an artesian aquifer. I am currently running the model in steady-state, and the pressure head distribution is making sense so far from preliminary results. However, I have no velocity contours or vectors in the results section. Since this is a dynamic stead-state model, this doesn't make any sense to me.

Any ideas?

Thanks

Re: No velocity or velocity vector results

Posted: Tue Sep 25, 2018 6:51 am
by Jirka
I think that it is practically impossible that you would get results for pressure heads and water contents and not for velocities/fluxes. You either get all three of them (when modeling water flow) or none of them. J.