Yellow Arrow

A discussion forum for users of the new HYDRUS 2D/3D. HYDRUS is a software package for simulating water, heat and solute movement in two- and three-dimensional variably saturated media. Happy Posting!
Post Reply
rryland
Posts: 2
Joined: Tue Nov 08, 2016 4:26 pm
Location: USA

Yellow Arrow

Post by rryland » Mon Mar 20, 2017 3:38 pm

While running a HYDRUS 2D/3D model I received an error message that follows, along with a yellow arrow:

The follow properties (or conditions) have different values on the FE-Mesh and Geometric objects;
Root Water Uptake
Water Flow Boundary Condition
Pressure Head Initial Condition

I don't understand what this message means.

Thanks you for your time,
Rachel

Jirka
Posts: 4759
Joined: Sat Mar 16, 2002 3:47 pm
Location: USA
Location: Riverside, CA

Re: Yellow Arrow

Post by Jirka » Mon Mar 20, 2017 3:56 pm

You have likely selected the mode of specifying properties on Geometrical Objects and then specified selected properties directly on Finite Element Mesh. When there is a difference between properties specified in these two modes, Hydrus will issue this warning. The model gives priority to information specified on FE Nodes. J.

Post Reply