Constant water content boundary condition

A discussion forum for users of the new HYDRUS 2D/3D. HYDRUS is a software package for simulating water, heat and solute movement in two- and three-dimensional variably saturated media. Happy Posting!
Post Reply
kshubhankar
Posts: 9
Joined: Thu Mar 09, 2017 10:08 am
Location: India

Constant water content boundary condition

Post by kshubhankar » Thu Mar 09, 2017 10:30 am

Hi
I would like to know how give constant water content boundary condition in Hydrus 2D/3D. Previously I was using Hydrus 1D where this particular boundary condition was available.

Jirka
Posts: 4712
Joined: Sat Mar 16, 2002 3:47 pm
Location: USA
Location: Riverside, CA

Re: Constant water content boundary condition

Post by Jirka » Thu Mar 09, 2017 5:12 pm

You can specify constant pressure heads or water contents boundary conditions only when you select that the initial condition is specified in terms of the pressure heads or water contents, respectively. This BC has to use the same mode as initial conditions. The selection is made in the Water Flow->Iteration Criteria window.

J.

kshubhankar
Posts: 9
Joined: Thu Mar 09, 2017 10:08 am
Location: India

Re: Constant water content boundary condition

Post by kshubhankar » Wed Mar 15, 2017 11:20 am

Thank you very much

Post Reply